Return Permeability Ceramic Sintering Furnace / Industrial Vacuum
Sintering Furnace
Equipment description:
On the whole, it meets the strict requirements of temperature
uniformity and atmosphere uniformity in powder metallurgy.The
furnace structure design is advanced and reasonable, which is
convenient for operation and maintenance.The main supporting
components (sensors, graphite heating element, thermocouple, main
control valve, vacuum pump, etc.) have the international advanced
level and can adapt to the long-term, stable and reliable mass
production requirements.At the same time, the equipment should also
meet the national requirements for energy conservation and
environmental protection.
Equipment function:
Realize the function of vacuum sintering and rapid cooling;The
whole process of manual button operation, temperature control using
Yokogawa-550 instrument temperature control.
Working environment of plant:
Humidity and temperature requirement
Environment humidity: ＜90%(at +35℃)
Environment temperature: -10℃～45℃
Power supply
Motive power supply: 375V--430V,50Hz,3 phase 5 wire system;Heating
power:600KVA
Control power supply(China standard): 210V～250V,50Hz,Single-phase
Water:Totally enclosed circulating water
Gas:
Process gas:Ar,N2
Compressed air pressure: 0.6MPa ～0.8MPa
Technical paremeter table
| Design run times | 300 furnace/year |
| Valid working zone size | 500mm×500mm×1500 mm (W×H×L) |
| Max.loading capacity | ≥1000Kg(It depends on the product type) |
| Max.working temperature | 1400℃ |
| Pumping speed | The vacuum degree can reach 5Pa, and then pump within 30min after
reaching 5Pa. The ultimate vacuum value should reach 1Pa (in the
case of cold, air and dry after heating up furnace). |
| Leakage rate | ≤2Pa/h(after testing the limit vacuum, empty furnace, clean and
cold state,average value winthin 12 hours) |
| Max.positive pressure | 10KPa |
| Rapid cooling time≤8h | |
| Max.heating up speed(full loading) | ≥6℃/min |
| Heating power | proximately 220KW |
| Loading plate size | 720*480*35mm(2 plate) |
After sales:
1.Installation, Commissioning And Acceptance
We do installation, commissioning and acceptance in buyer's
plant.During the installation and commissioning period, the
commissioning personnel shall be provided free of charge by the
demander according to the staff standard.
The equipment shipped to the buyer, the seller received the buyer's
notification, both within a week to carry the equipment out of the
box together, then check the equipment and all components according
to the packing list . Including equipment accessories, spare parts
and special tools, attached manual and technical documents, etc. It
can be installed after the acceptance check of equipment.
After installation and debugging, the equipment shall be accepted
according to the technical accessories.
2.Training
When taking-over the Furnace to the customer, We will give a staff
training to customer. The operating personnel of the customer
should join to commission,test the furnace, when installing at
customer’s company.
This is practical operation training and practical maintenance
training,
and our technical personnel will telling the basic
principle,equipment maintenance knowledge,And the common fault
handling measures.We can training 2 ~ 3 workers. ( Training how to
maintenance and operating.)
3. warranty period
The warranty period of the equipment is 12 months, which starts
from the date of installation and debugging of the supplier.
Equipment failure happens, after-sales service personnel shall give
solutions within 2 hours, after receiving the buyer's notification
. If it is need to go to the site for treatment , operators
dispatched by seller should arrive at the site within 48 hours
after go aboard. In case of emergency,operators should arrive at
the site within 48 hours after go aboard, and continue to make
repairs until the fault is removed and the equipment returns to
normal.
